Drainage System A Seamless way to dispose water
| by saimaxx | July 29, 2008
Drainage is the disposal of excess water on land (either used or in form of storm water). It must be distinguished from flood control which is the prevention of damage as a result of overflow from river. There are two type of system adopted for waste water collection. Separate sanitary and combined system. In separate sanitary system, there is a separate sewer that collects the household, commercial and industrial waste water and disposes them while a separate sewer collects the storm water and disposes it separately. In the combined system, both the storm water and domestic water are conveyed through the same pipe network.
The overall steps in layout sewers include:
Establish comprehensive map of the area including road contour, topography and utilities
Drains are shown with a single line with arrows for direction
Manholes are shown with a dot at all its necessary locations as the junctions and its intermediate point of 100-120m interval
Sewers are design to follow natural topography
Sewers are mostly branch network
Sewers or drains are usually located along the road
Design approach for sewers is as follows;
Estimate manning constant and select slope
Compute the section factor
Get the best hydraulic section either rectangle or trapezoid
Check the satisfaction of minimum velocity
Addition of adequate freeboard to avoid overflowing
The disposal of the waste water could be treated or not treated. However, the treatment is usually by biological method. The disposal of waste water is of immerse important for economic growth. The treated or untreated waste could be used as a source of irrigation, supplement stream or river flow and could be used as a source of recharge for ground water.
Seamless gutters are made out of a variety of materials which can range from aluminum, steel that has been galvanized, vinyl and copper. If you are wondering if you can match the color scheme of the exterior of your house, that's no problem. It can be made in any color, so matching it to your home's exterior will not be a problem.
If you're budget conscious then you should be aware that seamless gutters are more expensive than traditional gutters, so you should be prepared to spend a little more money on these gutters, although it is not that much more.
It is obvious in the cities of the developing countries that the most of construction industries do not take note of all the above mentioned process. As a result storm water follows drains that are not specified for them or overflows the drains there by causing erosions. On the other hand, some of the storm water are stagnant in the drains there by becoming a breeding place for mosquitoes and toads. This could result in increase of malaria and water related disease in the vicinity. All this is because; most government in such cities have not yet understand the important of drainage systems and the role it plays in social- economic development.
To learn more details about our products and services, visit- http://saimaxx.com/pipesproducts.html
The overall steps in layout sewers include:
Establish comprehensive map of the area including road contour, topography and utilities
Drains are shown with a single line with arrows for direction
Manholes are shown with a dot at all its necessary locations as the junctions and its intermediate point of 100-120m interval
Sewers are design to follow natural topography
Sewers are mostly branch network
Sewers or drains are usually located along the road
Design approach for sewers is as follows;
Estimate manning constant and select slope
Compute the section factor
Get the best hydraulic section either rectangle or trapezoid
Check the satisfaction of minimum velocity
Addition of adequate freeboard to avoid overflowing
The disposal of the waste water could be treated or not treated. However, the treatment is usually by biological method. The disposal of waste water is of immerse important for economic growth. The treated or untreated waste could be used as a source of irrigation, supplement stream or river flow and could be used as a source of recharge for ground water.
Seamless gutters are made out of a variety of materials which can range from aluminum, steel that has been galvanized, vinyl and copper. If you are wondering if you can match the color scheme of the exterior of your house, that's no problem. It can be made in any color, so matching it to your home's exterior will not be a problem.
If you're budget conscious then you should be aware that seamless gutters are more expensive than traditional gutters, so you should be prepared to spend a little more money on these gutters, although it is not that much more.
It is obvious in the cities of the developing countries that the most of construction industries do not take note of all the above mentioned process. As a result storm water follows drains that are not specified for them or overflows the drains there by causing erosions. On the other hand, some of the storm water are stagnant in the drains there by becoming a breeding place for mosquitoes and toads. This could result in increase of malaria and water related disease in the vicinity. All this is because; most government in such cities have not yet understand the important of drainage systems and the role it plays in social- economic development.
To learn more details about our products and services, visit- http://saimaxx.com/pipesproducts.html
Article Source: http://www.articleset.com

You are welcome to publish or reprint this article free of charge, provided:
- you include the entire article, unchanged, including the "About The Author" box
- all hyperlinks remain active, including the bottom ArticleSet.com link (does not apply to print publications)
- you agree not to hold the authors nor ArticleSet.com liable for any loss profits, expenses, or any other damages resulting from the use or misuse of articles published on this website